Getting Started • MIDI
58
To solve this problem, you need to transpose an octave
below the accordion bass.
Dynamics
Not all accordions can transmit Velocity messages (e.g.
the dynamics, or intensity, notes are played with).
However, in the iS35 you can select the fixed dynamics
value used to receive the notes sent by the accordion.
The MIDI “Accordion 1” and “Accordion 2” setups
automatically select a fixed dynamics value. If the
value is not appropriate for your accordion, you can
edit the “Velocity Input” parameter in the Disk/Global
mode (see page 151).
The MIDI “Accordion” Setups
The following table shows the iS35 tracks that corre-
spond to each of the 16 MIDI channels according to the
selected MIDI “Accordion” setup. It also shows the
value of the “Velocity Input” parameter.
With the MIDI programmable accordions, you can
select the MIDI channel used to send the different
parts, that is the correspondence between the iS35
parts and the accordion parts.
Accordion 1. The “Accordion 1” setup is dedicated to
those who have an accordion with three fixed channels
(with no assignable MIDI channel). With this setup
you can play Upper 1 and Upper 2 with your right
hand, Lower with the chords and the iS35 bass with
the accordion bass.
?
?
?
˙
˙
˙
˙
˙ ˙
˙
˙
˙
C/G
˙
bass
chords
real bass
actually detected bass
detected
chord
Accordion 1 Accordion 2 Accordion 3
Chan. Track Track Track
1 Global
(Upper 1 + Upper
2)
Upper 1 Upper 1
2 Lower + Chord 1 +
Harmony
Lower + Chord 1 +
Harmony
Lower + Chord 1 +
Harmony
3 Bass +
Chord 2
Chord 2 Bass +
Chord 2
4 – Upper 2 Upper 2
5–––
6–––
7–––
8–––
9–––
10 Drum Drum Arrangement
11 Perc Perc Perc
12 Bass Drum
13 Acc1 Acc1 Acc1
14 Acc2 Acc2 Acc2
15 Acc3 Acc3 Acc3
16 – Global Global
Velocity
Input
110 110 Normal
To Next Page
Loading...
Need help?
General
