120
5 Press the [REALTIME CONTROLS] key to make the “B”
LED light.
6 Rotate knob [1], [2] and the panning of the external input
sound and the delay will change. You can sample the
sound while you modify it.
5–1: Audio CD
Here you can sample the playback of an audio CD, or copy
digital information from an audio CD (“ripping”).
Sound can be sampled from an audio CD in the following
two ways.
• The analog audio output from an audio CD played in
the CDRW-1 option (if installed) is internally connected
to the AUDIO INPUT jacks. If you are using a CD-R/
RW drive connected to the SCSI connector, use audio
cables to connect the drive to the AUDIO INPUT jacks.
In either case, the procedure is the same as when sam-
pling analog audio from the AUDIO INPUT jacks. The
audio will play back on the TRITON STUDIO according
to the “Input” Analog (0–2a) settings. Set “Level,” “BUS
(IFX/Indiv.) Select” (normally set to L/R) for Input1 (L
channel) and Input2 (R channel).
• A certain passage of digital audio information stored on
audio CD (played in the installed CDRW-1 or a CD-R/
RW drive connected to the SCSI connector) can be
acquired in its digital state and saved as a sample. This
“ripping” function allows you to bypass the usual
Digital-to-Analog and Analog-to-Digital converters and
preserve the digital signal in its original state. Digital
ripping is executed by the page menu command
“Destination” (5–1A).
Some CD-R/RW drives do not support ripping (i.e., a
CD-R/RW drive that does not read CD-DA data). In
this case, the display will indicate “Error in reading
from medium.”
Use the various SEQUENCER keys to control the audio CD.
If the CDRW-1 option is installed, playing the keyboard
or operating the controllers during playback may pro-
duce physical shock that causes the playback to skip or
reading errors to occur, preventing playback from
occurring normally.
5–1a: Location
Location [00:00.0...]
Indicates the current location of the track being played
(“Track”). When stopped, this indicates the location at
which playback will begin. If you re-select “Track” or
“Index,” this will be 00:00.0.
Sampling P5: Audio CD
SEQUENCER [START/STOP] key : play/stop
[FF>>] key : fast-forward
[<<REW] key : rewind
[PAUSE] key : pause
[LOCATE] key : return to the beginning
of the track
5–1
5–1b
5–1c
5–1a
5–1d
To Next Page
Loading...
Need help?
General
