Kortho Hot Quick Coder-D Series - Power on

OPERATION
H215 AE Rev.: 10 kortho Hot Quick Coder-D
6-7
Whenthisparameterisset,thebusysignalissetfromthemomentthecontrolboxispoweredonuntilthe
printertemperature(
erprT int )hasreachedavalueequalorgreaterthanSETTEMP( setT )minusREADY
TEMP(
readyT ).
readyseterpr TTT −≥int 
ThepreferredREADYTEMPvaluesareOFFand-0°C,theothervaluesaremeantforspecialenvironments.
Whilethebusysignalisactive,theprinterignorestriggersignalsandwillnotprint.Thisparameterisusual
usedwithautomaticallycontrolledpackagingmachines.Itpreventsprintinguntiltheprinterhas
reached
(nearly)thedesiredprinttemperature.
Note:
ThebusysignalstatusisnotdisplayedwhenthebusysignalissetbytheREADYTEMPparameter,
onlytheoutputisset.
(Reminder:ThebusysignalstatusisdisplayedastheP‐iconwhentheprinterisprinting)
Pressbutton:
UPARROW toincreasetheparametervalue.
DOWNARROW todecreasetheparametervalue.
LEFTARROW toshifttotheEXT.BUSYparameter.
RIGHTARROW toshifttothePOWERONparameter.
STOP toreturntotheSTOPMODEMENUandstopprinting.

6.3.10 Power on
ThisparameterisonlyaccessiblefromtheREADYTEMPparameter.
Fig. 6.15 POWERONparameter.
ThePOWERONparametersetstheprintmodeatwhichthecontrolboxwillstartafterpoweron.This
parameterhastwopossiblesettings,STOPandRUN.Thecurrentparametervalueisrepresentedby****.
This
parameterisusualusedwithautomaticallycontrolledpackagingmachines.
Pressbutton:
UPARROW totoggletheparametertotheRUNvalue.
DOWNARROW totoggletheparametertotheSTOPvalue.
LEFTARROW toshifttotheREADYTEMPparameter.
STOP toreturntotheSTOPMODEMENUandstopprinting.
POWER ON
: ****
i