INSTALLATION
kortho Hot Quick Coder-D H215 AE Rev.: 10
5-4
2. Checkifalloftherelevantcablesareconnected.
3. Switchonthecontrolbox.Theprogrambootswhiletheprintertypeisdisplayed.
Fig. 5.7 FirmwareforPrintertypemessage.
4. After3secondstheStopmodemenuappears.
Fig. 5.8 STOPMODEmenu.
5. Pushthedownarrow,theprinter
willmakeaprintstrokeandtheprintheadwillstayinhis“out”
position.
Fig. 5.9 HEADOUTscreen.
4. Screwthehandleinthetextholder.
5. Placethetextholderinthetextholderslot.
6. Removethehandlefromthetextholder.
7. Pushtheuparrow.
Thetextholderslotwillreturntohishomepositionandthecontroleunitwillshow
theSTOPMODEmenu.
CAUTION:
Notremovingthehandleformthetextholderbeforereturningtheprintheadtohishomeposition
candamagethecodingunit.
5.5.3 Placing a hotroll
1. Checkbyvisualinspectionfordamageoftheprinter.
2. Checkifalloftherelevantcablesareconnected.
3. Switchonthecontrolbox.Theprogrambootswhiletheprintertypeisdisplayed.
Fig. 5.10 FirmwareforPrintertypemessage.
To Next Page
Loading...
