8 VS-42UHD - Connecting the VS-42UHD
4 Connecting the VS-42UHD
Always switch off the power to each device before connecting it to
your VS-42UHD. After connecting your VS-42UHD, connect its
power and then switch on the power to each device.
You do not have to connect all the inputs and outputs, connect only
those that are required.
To connect the VS-42UHD, as illustrated in the example in Figure 3
, do the
following:
1. Connect up to four HDMI sources, (for example, Blu-ray Disc players) to the
HDMI Input connectors.
2. Connect the two OUT HDMI connectors to up to two HDMI acceptors, (for
example, LCD displays with built-in speakers).
3. If required, connect a PC/controller to the RS-232 port (see Section 4.1
)
and/or the Ethernet port (see Section 4.2).
4. Connect the power adapter to the device and plug the power adapter into
the mains electricity (not shown in Figure 3
).
5. If required, acquire the EDID (see Section 6.1).
To Next Page
Loading...
Need help?
General
