10 VS-42UHD - Connecting the VS-42UHD
Note: If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.
4.2.1 Connecting the Ethernet Port Directly to a PC
You can connect the Ethernet port of the VS-42UHD directly to the Ethernet port on
your PC using a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the VS-42UHD
with the factory configured default IP address.
After connecting the VS-42UHD to the Ethernet port, configure your PC as
follows:
1. Click Start > Control Panel > Network and Sharing Center.
2. Click Change Adapter Settings.
3. Highlight the network adapter you want to use to connect to the device and
click Change settings of this connection.
The Local Area Connection Properties window for the selected network
adapter appears as shown in Figure 4
.
Figure 4: Local Area Connection Properties Window
To Next Page
Loading...
Need help?
General
