20 VS-42UHD - Configuring and Maintaining the VS-42UHD
7.2 Resetting the VS-42UHD to Factory Default Settings
To reset the device to factory default settings:
1. Power the device off.
2. Press and hold down the Reset button on the rear panel.
3. While holding down the Reset button, power on the device.
4. Wait a few seconds and release the button.
The device is reset to its factory settings.
7.3 Upgrading the Firmware
The VS-42UHD can be upgraded via any of the following:
• Mini USB
• RS-232
• Ethernet
For instructions on upgrading the firmware see “K-Upload Software”.
To Next Page
Loading...
