Kramer VS-42UHD - 7 Configuring and Maintaining the VS-42 UHD; 7.1 Setting the DIP-Switches

VS-42UHD - Configuring and Maintaining the VS-42UHD 19
7 Configuring and Maintaining the VS-42UHD
This section describes the configuration and maintenance of the VS-42UHD and
consists of:
• Setting the DIP-switches (see Section 7.1
)
• Resetting the device to factory default settings (see Section 7.2)
• Upgrading the firmware (see Section 7.3)
7.1 Setting the DIP-Switches
The DIP-switches dictate the behavior of the VS-42UHD.
All DIP-switches are off by default.
#
Feature
Description
1 HDCP support on inputs On—Disable HDCP support on all inputs
Off—Enable HDCP support which is defined by P3000
commands
2 Video mode switching
Output 1
On—Auto
Off—Manual
3 Last connected/Priority
mode Output 1
When DIP-switch 2 is set to Auto (ON):
On—Enable Last Connected mode
Off—Enable Priority mode where the priority of each
input is defined by the input number, (1 is the highest
priority)
4 Video mode switching
Output 2
On—Auto
Off—Manual
5
Last connected/Priority
mode Output 2
When DIP-switch 4 is set to Auto (ON):
On—Enable Last Connected mode
Off—Enable Priority mode where the priority of each
input is defined by the input number, (1 is the highest
priority)
6
N/A
–
7
N/A
–
8 N/A –