Kramer VS-88H2

Kramer Electronics Ltd.
VS-88H2 – Operating VS-88H2 via Front Panel Buttons
20
VS-48H2
A pattern is selected by pressing inputs 1 to 4 when in the Pattern mode as follows:
• When MUTE/PATTERN is illuminated, press IN1 for pattern 1, IN 2 for pattern 2, IN
3 for pattern 3 and IN 4 for pattern 4.
• When MUTE/PATTERN flashes, press IN1 for pattern 5, IN 2 for pattern 6.
To route a pattern on the VS-48H2:
1. Press MUTE/PATTERN .
▪ Once: button illuminates, press IN 1 to IN 4 to select patterns 1 to 4.
▪ Twice: button flashes, press IN 1 to IN 4 to select patterns 5 to 6.
On the front panel buttons:
• An illuminated output button means that a display is connected on that output.
• An illuminated input button indicates the current pattern selected.
On the 7-segment display:
• “P” under an output number indicates that a pattern is routed to that output.
• “-” under an output number indicates that a video input is routed to that output.
• “0” under an output number indicates that the output is muted.
2. Press an OUT (MUTE) button (1 to 8).
The 7-segment display LED, under the selected output, flashes.
Press ALL (instead of an output button) to route a pattern to all the outputs. All the
7-segment display LEDs flash.
3. Press an input button to select a pattern (see Figure 15).
The 7-segment display shows the new pattern status.
Press VIDEO or D-AUDIO to exit pattern mode.
VS-66H2
A pattern is selected by pressing inputs 1 to 6 when in the Pattern mode as follows:
• When MUTE/PATTERN is illuminated, press IN1 for pattern 1, IN 2 for pattern 2, IN
3 for pattern 3, IN 4 for pattern 4, IN 5 for pattern 5 and IN 6 for pattern 6.
To route a pattern on the VS-66H2:
1. Press MUTE/PATTERN .
▪ Once: button illuminates, press IN 1 to IN 6 to select patterns 1 to 6.
4
3
3
3
1
3
3