Performing a Factory Reset
To reset the device to its factory default values:
1. In the Navigation pane, click Device Settings.
The Device Settings page appears (Figure 29).
2. Click Reset. The following window appears:
Figure 30: Device Settings Page – Factory Reset
3. Click OK to start factory reset and follow the instructions on-screen.
This feature can also be performed manually on VS-88H2:
• Press and hold the Reset Button (Figure 5) while powering the device to reset IP
settings to factory default values.
Performing Firmware Upgrade
• This section contains information on upgrading the firmware using webpages. For
information on upgrading the firmware using By USB or RS-232 using Kramer
K-UPLOAD tool, go to Kramer Web site at www.kramerav.com/downloads/VS-88H2.
To perform firmware upgrade:
1. In the Navigation pane, click Device Settings.
The Device Settings page appears (Figure 29).
2. Click BROWSE and select the new firmware file.
3. Click START UPGRADE and follow the instructions on-screen.
To Next Page
Loading...
