Krone EasyCut 2801 CV - Lighting; Lighting Connection

Start-up
31
Pos: 16.24 /Übersc hriften/Überschri ften 2/A-E/Beleuchtung @ 0\ mod_1195658399935_78. docx @ 1881 @ 2 @ 1
6.4 Lighting
Pos: 16.25 /BA/Sic herheit/Fahren und Transp ort/Beleuchtung/B eleuchtungsanlag e alle Maschinen @ 7\mod_1215 519058839_78.doc x @ 103206 @ @ 1
Danger! - Lighting system
Effect: Danger to life, serious injuries or serious damage to the machine.
• Before transporting on public roads, always connect the lighting system and perform a
function check.
• Keep the lighting system clean. Soiled lights and spotlights impair road safety.
• Replace defective light bulbs or broken spotlights.
• When transporting on public highways, the machine must be in the transport position.
Pos: 16.26 /BA/Inbetr iebnahme/EasyCut/Be leuchtung/Ansc hluss Beleuchtung T1 EC 2800/ 3200/3210/4013 @ 10\m od_1222070676913_7 8.docx @ 138674 @ 2 @ 1
6.5 Lighting connection
To comply with the Road Traffic Licensing Regulations, the machine is equipped as follows by
default:
• at the front with white clearance lamps (3)
• 3-chamber rear lamps (4) (direction indicator: reversing light and brake light)
• with red reflectors on the rear (5)
Pos: 16.27 /BA/Inbetr iebnahme/EasyCut/Be leuchtung/Ansc hluss Beleuchtung T2 Bi ld EC 2800/3200/2801/320 1/3600 @ 129\mod_134667 7007317_78.doc x @ 1153135 @ @ 1
EC-063-1
Figure 10
Pos: 16.28 /BA/Inbetr iebnahme/EasyCut/Be leuchtung/Ansc hluss Beleuchtung T3 EC 2800/ 3200 3210/4013/7540/ 9140 @ 11\mod_1222421634 749_78.docx @ 141790 @ @ 1
The lighting system is connected via the 7-pin connection cable (2).
To do this:
• Insert the 7-pin connection cable plug (2) into the appropriate socket (1) of the machine.
• Insert the 7-pin connection cable plug (2) into the appropriate socket of the tractor.
• Position the cable so that it will not come in contact with the wheels.
Pos: 16.29 /BA/Inbetr iebnahme/Schwader /Hinweis Sauberkei t der Stecker und Steckdose n @ 2\mod_1202399563131_7 8.docx @ 59273 @ @ 1
Note
Before inserting the plugs, make certain the plugs and sockets are clean and dry. Dirt and
moisture may result in short circuits!
Pos: 16.30 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1