KTM RC 250 R - Page 69

18 SERVICE WORK ON THE ENGINE 67
L00500-10
–
Remove screw plug
2
with oil screen
3
and the O-rings.
– Completely drain the engine oil.
– Thoroughly clean the parts and sealing surfaces.
– Mount and tighten the screw plug with the oil screen and the O-rings.
Guideline
Plug, oil screen M32 40 Nm
(29.5 lbf ft)
L00501-10
–
Mount the oil drain plug
1
with the magnet and seal ring and tighten it.
Guideline
Oil drain plug M12 30 Nm
(22.1 lbf ft)
L00555-10
–
Remove screws
4
. Take off the oil filter cover with the O-ring.
L00521-11
–
Pull oil filter
5
out of the oil filter housing.
– Completely drain the engine oil.
– Clean the parts and the sealing surface thoroughly.
L00521-12
– Insert the oil filter into the oil filter housing.
–
Grease the O-ring of the oil filter cover and mount it with the oil filter cover
6
.
– Mount and tighten the screws.
Guideline
Remaining engine screws M6 10 Nm (7.4 lbf ft)
L00597-11
–
Remove the oil filler plug
7
with the O-ring from the clutch cover and fill up with
engine oil.
Engine oil 0.75 l (0.79 qt.) Engine oil (SAE 0W/40) ( p. 94)
Info
Too little engine oil or poor-quality engine oil results in premature wear to
the engine.
– Install and tighten the oil filler plug with the O-ring.