KTM RC 250 R - Page 71

18 SERVICE WORK ON THE ENGINE 69
– Remove the cooling air guide, radiator hoses, and radiator.
– Remove the main silencer, connecting pipe, and exhaust pipe.
– Remove the sprocket.
– Remove the shift linkage.
– Disconnect the ground wire and all plug-in connections.
– Remove the front air intake.
– Pull off the engine breather hose.
– Loosen the hose clip of the throttle valve body and pull off the throttle valve body.
The throttle valve body can remain on the vehicle.
– Remove the thrust bearing of the clutch cable and detach the clutch cable from the
eyelet of the clutch release lever.
L00662-11
Main work
– Support the engine with the scissors stand.
–
Remove the front engine bracket screw
1
with the washer.
L00663-11
–
Remove the front engine bracket screw
2
with the washer.
L00664-14
–
Remove nut
3
and nut
4
with the washers.
L00666-11
–
Remove the lower engine bracket screw
5
and loosen the lower adjustable engine
spacer
6
by approx. ten rotations.
L00665-11
–
Remove the upper engine bracket screw
7
and loosen the upper adjustable
engine spacer
8
by approx. ten rotations.