26 STANDARDS 96
JASO T903 MA
Different technical development directions required a new specification for 4-stroke motorcycles – the JASO T903 MA Standard. Ear-
lier, engine oils from the automobile industry were used for 4-stroke motorcycles because there was no separate motorcycle specifi-
cation. Whereas long service intervals are demanded for automobile engines, high performance at high engine speeds are in the fore-
ground for motorcycle engines. In most motorcycles, the gearbox and the clutch are lubricated with the same oil as the engine. The
JASO MA Standard meets these special requirements.
SAE
The SAE viscosity classes were defined by the Society of Automotive Engineers and are used for classifying oils according to their vis-
cosity. The viscosity describes only one property of oil and says nothing about quality.
To Next Page
Loading...
Need help?
General
