KUHN GMD16 - 8. Instructions for work; 8.1 Putting the machine into work position

8. - Instructions for work
GMD16-GMD20
53
KN225BGB_A
Disc mower
8. Instructions for work
8.1 Putting the machine into work
position
From the transport position:
- Fully lift tractor lift linkage.
- Activate single acting valve of transport/work
positioning cylinder to lighten pressure on
transport lock.
- Pull the release cord until transport lock is released
(1).
- Place the single acting valve of the mowing unit lift
cylinder in floating position to lower the mowing
unit.
Before placing the machine in working
position:
- Check that nobody is within the
machine pivoting area.
- If there is someone, make sure the
person moves away.
When optional equipment is used, follow
specific procedures mentioned in the related
section:
• Optional equipment / Manual
hydraulic cutter bar lift pump.
1