KUHN GMD16 - 10.4 Storage; 10.4.1 At the end of each season; 10.4.2 At the start of each season

10. - Maintenance and storage
GMD16-GMD20
83
KN225BGB_A
Disc mower
10.4 Storage
10.4.1 At the end of each season
- Clean the machine thoroughly.
- Drain gearbox and cutterbar and refill with new oil.
- Grease the cylinder rods in contact with the
outside.
- Touch up any areas of damaged paintwork.
- Store machine with the cutter bar in horizontal
position in a sheltered dry place.
- Inspect and replace worn knives and bolts.
- Release belt tension.
10.4.2 At the start of each season
- Re-read the operators' manual.
- Inspect and replace worn knives and bolts.
- Check that all nuts and bolts are sufficiently
tightened.
- Check belt condition. Replace them if necessary.
- Check belt tension. Retension if necessary.
- Wipe off grease on cylinder rods.
- Make sure that all protection devices are in place
and in good condition.
A7300019 0