KUHN GMD16 - 6.2.3 Preparing the machine

6. - Putting into service
GMD16-GMD20
43
KN225BGB_A
Disc mower
6.2.3 Preparing the machine
 Positioning of lower links
- Measure dimension E.
- Adjust the side stabilizers of the tractor's lower
links to obtain a measure E of 50 mm (2’’).

Linkage adjustment
- Measure dimension A.
For attachment category 1
If measure A is below 2.10 m (6’11’’):
- Adjust machine lower hitch pin position:
• Loosen the 2 counter-nuts (1).
• Unscrew the 2 bolts (2).
• Place hitch pins (3) and (4) in the required
position:
• X: 683 mm (2’3’’).
• Tighten the 2 bolts (2).
• Tighten the 2 counter nuts (1).
- Place lower links in position a.
When optional equipment is used, follow
specific procedures mentioned in the related
section:
• Optional equipment / Manual
hydraulic cutter bar lift pump.
E
A
A
X
2
3
1
4
2
1
a