7-10
Setup Mode and the Setup Editor
The Channel/Program (CH/PROG) Page
Figure 7-1 Soloing Zones With the K2600R
The K2600 keyboardÕs mode-selection buttons also light as shown above. However, buttons 1Ð8
are more convenient for muting, unmuting, and soloing zones.
Output Assignment (Out)
This determines the signal routing for each zone in the setupÑnot the Þnal audio output, but
the KDFX input to which the zoneÕs signal gets sent. You can route the zone to KDFX A
through D, or you can use a value of Prog, which uses the output assignments of the program
thatÕs assigned to that zone.
Zoom +
Mute 2
P
rogram
Mute 1
Zoom -
Access
Samp/Sec
Mute 3
etup
QS
Zoom +
Mute 2
P
rogram
Mute 1
Zoom -
Access
Samp/Sec
Mute 3
etup
QS
Zoom +
Mute 2
P
rogram
Mute 1
Zoom -
Access
Samp/Sec
Mute 3
etup
QS
Zoom +
Mute 2
P
rogram
Mute 1
Zoom -
Access
Samp/Sec
Mute 3
etup
QS
Zoom +
Mute 2
P
rogram
Mute 1
Zoom -
Access
Samp/Sec
Mute 3
etup
QS
Setups Containing 3 or Fewer Zones
Setups Containing 4 or More Zones
Press Mute 2 or Mute 3,
and the current zone is soloed; press
Chan/Bank buttons to solo each zone.
Press Mute 1, and the current zone
is muted.
Zoom +
Mute 2
P
rogram
Mute 1
Zoom -
Access
Samp/Sec
Mute 3
etup
QS
Current zone active; one or more other
zones muted.
All zones muted.
One or more zones muted, including
current zone.
All zones active.
Zoom +
Mute 2
P
rogram
Mute 1
Zoom -
Access
Samp/Sec
Mute 3
etup
QS
Press Mute 1, Mute 2, or Mute 3 to
mute each zone.
Zoom +
Mute 2
P
rogram
Mute 1
Zoom -
Access
Samp/Sec
Mute 3
etup
QS
All zones active.
To Next Page
Loading...
