Kurzweil K2600 - The PITCH Page; Fine Hz

Program Mode and the Program Editor
The PITCH Page
6-27
The PITCH Page
Press the PITCH soft button, and the PITCH page will appear. These parameters adjust the pitch
(playback rate) of the samples after the root has been selected by the keymap.
EditProg:PITCH|||||||||||||<>Layer:1/1||
Coarse:0ST|||||||||Src1||:OFF|||||||||||
Fine||:0ct|||||||||Depth|:0ct|||||||||||
FineHz:|0.00Hz|||||Src2||:OFF|||||||||||
KeyTrk:0ct/key|||||DptCtl:MWheel||||||||
VelTrk:0ct|||||||||MinDpt:0ct|||||||||||
|||||||||||||||||||MaxDpt:0ct|||||||||||
<more||ALG||||LAYER||KEYMAP|PITCH||more>
These parameters were described in the section on common DSP control parameters earlier in
this chapter, so we wonÕt repeat them here, but a word about the Fine Hz parameter is in order.
Fine Hz
This measures pitch adjustment by the relative frequency (in Hertz) of each note. This is useful
for controlling the beat frequency between layers in a multi-layered program. Using this
parameter to detune chorusing layers will keep the beat frequency constant across much of the
keyboard. Although the ratio of frequencies between each layer remains constant, the detuning
will increase at lower pitches, and can become extreme. The K2600 automatically limits the
amount of detuning when it becomes extreme, so youÕll notice the beat frequencies moving out
of sync when you play low pitches.
The F1–F3 Pages
These pages are reached by pressing the F1, F2, and F3 soft buttons, respectively. They contain
the parameters governing the three variable DSP functions in each algorithm. The pages vary
depending on the DSP functions selected for the three middle DSP control inputs, represented
by the downward-pointing arrows on the ALG page. See the MusicianÕs Reference for a complete
list of the algorithms and their available DSP functions.
Parameter Range of Values Default
Coarse Adjust –120 to 60 ST (Semitones) 0
Fine Adjust (Cts) ± 100 Cents 0
Fine Adjust (Hz) ± 6 Hz 0
Key Tracking ± 2400 Cents per key 0
Velocity Tracking ± 7200 Cents 0
Source 1 Control Source List Off
Depth ± 7200 Cents 0
Source 2 Control Source List Off
Depth Control Control Source List Mwheel
Minimum Depth ± 7200 Cents 0
Maximum Depth ± 7200 Cents 0