Kurzweil K2600 - The MIDI Control Source List

7-24
Setup Mode and the Setup Editor
Controllers
The MIDI Control Source List
Here are the available values for the Destination parameter for each controller, in scrolling order:
MIDI
Controller
Number
Corresponding
Destination
Name
Description
0 Off Turns physical controller off
1 MWheel Default Assignment for Mod Wheel
2 Breath Default Assignment for CC Pedal 2
3 MIDI 03
4 Foot Default Assignment for CC Pedal 1
5 PortTim Monophonic K2600 programs respond to this controller if
portamento is turned on
6 Data Almost all K2600 programs respond to this controller with DSP
sweeps and effects
7 Volume MIDI Volume
8 Balance MIDI Balance
9 MIDI 09
10 Pan MIDI Pan–programs which use the PANNER algorithm will
respond to real-time pan adjustments; all other programs will
respond on the next note start
11 Express MIDI Expression–an attenuator for fading in and out. It scales
between minimum (0) and the current value of Volume
12–14 MIDI 12–14 MIDI Controllers 12–14
15 Aux Bend 2 Default destination for Small Ribbon
16 Ctl A
17 Ctl B
18 Ctl C
19 Ctl D
20 MIDI 20
21 Aux Bend 1 Default destination for Large Ribbon
22–31 MIDI 22–31 MIDI Controllers 22-31. Almost all K2600 programs respond to
MIDI 22–29 in one way or another. In the default control setup
(97 ControlSetup) and in most other factory setups, Sliders B–H
send MIDI 22–28, and Panel Switch 2 sends MIDI 29.
Special Function Controllers
When you enter numbers 32–46 on the numeric buttonpad, you select one of the K2600’s Special
Functions. Entering 47–63 sets a physical controller’s Destination to Off. Note that these are not MIDI
Controller numbers; they’re the K2600’s internal global control numbers
32 MPress Default destination for Press and Small Ribbon Pressure
(SmPrs)
33 BendUp Default destination for Pitch Wheel
34 BendDwn Physical controllers bend in opposite direction of BendUp
Table 7-5 MIDI Control Source List