Kurzweil K2600 - Creating Directories; Creating a Directory from the Disk Mode Page

13-12
Disk Mode
Creating Directories
Pressing the Right cursor takes you two entries further to the next directory:
DOORS||||.K26*||3456K||
E4PROG|||.K26|||||10K||
LONGSMPS|||||(dir)|||||
LUTE|||||.K26*||||.5K||
MOON|||||.K26*||3456K||
TRIANGLE|.K26|||||10K||
or, pressing the Left cursor takes you two entries back to the previous directory.
ALTO|||||||||(dir)|||||
BOOBAMS||.K26*||||.5K||
CYMBALS||||||(dir)|||||
DOGS|||||.K26||||122K||
DOORS||||.K26*||3456K||
E4PROG|||.K26|||||10K||
Creating Directories
As stated above, you can create directories for organizing your K2600 Þles, whether you are
using SCSI or ßoppy disks. You can create directories on any disk formatted by a K2600, K2500,
or K2000.
Directories appear in the normal Þle list with the indicator (dir) to the right of the directory
name.
There are two ways to create new directories.
¥ Press the NewDir button while on the Disk-mode page
¥ Press the NewDir button during the Save dialog.
Creating a Directory From the Disk Mode Page
When you press NewDir, the K2600 prompts you for the directory name:
|||||||||||||||||||||||||<>KbdNaming:Off
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Directory|name:|THINGS||||||||||||||||||
||||||||||||||||||||||V|||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Delete|Insert|>>End||Choose||OK|||Cancel
Pressing >>End will take the cursor to the last character in the name. The Choose button allows
you to grab a Þlename from the current disk (see the discussion of Þle-name grabbing, in More
Features of the Save Dialog on page 13-28). Otherwise, the name will default to either NEWFILE
after a powerup, or the name will be that of the most recent Þle saved or loaded. Once you
choose a name to start with (or the default), you can edit the name using the Left and Right