Kurzweil K2600 - Studio

9-6
Basic Effects Mode
The Effects Mode Page
When FX Mode is Program
The available values for FX Chan are Current, and 1Ð16. When FX Chan is Current, studio
selection is determined by whatever program is assigned to the current K2600 channel (as
shown in the top line of the display in Program mode or Effects mode). That programÕs FXMods
are also enabled, and they respond to MIDI Controller messages received on the current
channel.
When FX Chan is any value from 1 to 16, studio selection is determined as follows: in Program
mode itÕs determined by the program assigned to that channel; in Setup mode, itÕs determined
by the program in the zone assigned to that channel. FXMods respond to MIDI Controller
messages as follows: in Program mode, the FXMods of the program on the channel speciÞed by
FX Chan respond to messages on that channel; in Setup mode, the FXMods of the program in
the zone using the channel speciÞed by FX Chan respond to messages on that channel.
The Studio parameter disappears, since studio selection is under program control.
When FX Mode is Setup
The only available value for FX Chan is None, since studio selection and FXMods are
determined by the program in Zone 1 of the current setup. The FXMods of the program in the
zone using the channel speciÞed by FX Chan respond to MIDI Controller messages on that
channel. The Studio parameter disappears, since studio selection is under setup control.
When FX Mode is Auto
The available values for FX Chan are Current, and 1Ð16. When FX Chan is Current, studio
selection and FXMods are determined as follows: in Program mode, itÕs determined by the
program assigned to the current K2600 MIDI channel; in Setup mode, itÕs determined by the
program in Zone 1 of the current setup; in Song mode (or during song playback regardless of
mode), itÕs determined by the program on the channel designated as the songÕs effects channelÑ
as speciÞed by the EffectChan parameter on the COMMON page in the Song Editor. FXMods
respond to MIDI Controller messages as follows: in Program mode, the FXMods of the program
on the K2600Õs current channel respond to messages on that channel; in Setup mode, the
FXMods of the program in Zone 1 of the current setup respond to messages on the channel used
by Zone 1.
When FX Chan is any value from 1 to 16, studio selection is determined as follows: in Program
mode itÕs determined by the program assigned to that channel; in Setup mode, itÕs determined
by the program in Zone 1 of the setup (ignoring the FX CHan setting). FXMods respond to MIDI
Controller messages as follows: in Program mode, the FXMods of the program on the channel
speciÞed by FX Chan respond to messages on that channel; in Setup mode, the FXMods of the
program in Zone 1 of the setup respond to messages on that channel (again, ignoring FX Chan).
Studio
When FX Mode is Master, the Studio parameter selects the studio for the entire K2600. When
FX Mode is Program or Setup, this parameter is unavailable, since setup selection and FXMods
are determined by program or setup selection. When FX Mode is Auto, setup selection and
FXMods are under program or setup control, but the Studio parameter is still available; its value
reßects the studio assignment for the program or setup that was current before you entered
Effects mode. You can change the value of the Studio parameter while in Effects mode, so you
can hear how different studios affect the current program or setup, without having to enter the
Program or Setup Editor. Any changes you make here revert to their previous settings when you
exit Effects mode.