Setup Mode and the Setup Editor
The Arpeggiator (ARPEG) Page
7-43
Real-time Control of Arpeggiator Parameters
You can have real-time control over several arpeggiator parameters, by assigning physical
controllers to special arpeggiator Controller Destinations. Any input (or entry value) from a
physical controller assigned to an arpeggiator Controller Destination overrides the programmed
values for the parameters. The override remains in effect until you select a setup (or in Program
mode, until you select a control setup on the MIDI-mode TRANSMIT page).
There are countless possibilities for conÞguring physical controllers for real-time control over
arpeggiator parameters. The following table covers just one possible conÞguration: Sliders AÐG
controlling each of the seven parameters that allow real-time control. WeÕve included some
suggested settings for the slider parameters, to make each slider at least reasonably useful for
arpeggiator control. These settings are based on an arpeggiator range from C 6 to C 8 (as set
with the LoKey and HiKey parameters on the ARPEG page).
Slider Assignment Suggested Slider Settings
A 40 ArpOrder
B 41 ArpBeats Scale = 10%; Add = 5
C 42 ArpShift Scale = 7%
D 43 ArpLimit Scale = 28%
E 44 ArpLmtOp
F 45 ArpVel
G 46 ArpDur
To Next Page
Loading...
