EasyManua.ls Logo

Kurzweil K2600 - Waveforms Combined with Nonlinear Functions

Kurzweil K2600
598 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16-52
DSP Functions
The DSP Functions
The parameters on the PWM control-input page affect the DC offset of the signal, in terms of the
percentage of shift from no offset to maximum offset. At a value of 0%, there is an offset positive
full scale. At 100%, the offset is negative full scale, and at 50%, there is no offset.
A typical control conÞguration for PWM has the Coarse Adjust set to 50%, an LFO assigned to
Src1, and Src1Õs Depth parameter set to a value of 25%.
The page below shows the PWM function in the F1 block, but it can appear in other blocks as
well.
EditProg:F1|WID(PWM)|||||||<>Layer:1/1||
Adjust:50%||||||||||Src1||:LFO1|||||||||
||||||||||||||||||||Depth|:25%||||||||||
||||||||||||||||||||Src2||:OFF||||||||||
KeyTrk:|0.0%/key||||DptCtl:OFF||||||||||
VelTrk:0%|||||||||||MinDpt:0%|||||||||||
Pad|||:0dB||||||||||MaxDpt:0%|||||||||||
<more||F1|WID|F2|||||F3|||||F4|AMP|more>
Waveforms Combined with Nonlinear Functions
The six functions in this category do one of two things: they combine samples and waveforms
with a nonlinear DSP function, or they use a waveform or sample as inputs to drive nonlinear
functions.
Added Sawtooth Wave with Nonlinearity (SW+DST)
This function starts by adding a sawtooth wave to the layerÕs sample input. When the input
signal from the sample is added to the sawtooth, the signal may exceed full scale, so a
wraparound function similar to WRAP is performed. The result is then squared to remove any
discontinuities from the wraparound. The resulting signal has a large DC offset, so a constant of
3/8 is subtracted.
Parameter Range of Values
Adjust 0 to 100%
Key Tracking ± 8.00% per key
Velocity Tracking ± 100%
Pad 0, 6, 12, 18 dB
Source 1 Control Source list
Source 1 Depth ± 100%
Source 2 Control Source list
Source 2 Depth Control Control Source list
Minimum Depth, Source 2 ± 100%
Maximum Depth, Source 2 ± 100%
Added Sawtooth with Nonlinearity (SW+DST) x Shape Mod Osc
Added Sawtooth plus Shaper (SW+SHP) + Shape Mod Osc
Shape-modulated Oscillator Amp-modulated Oscillator

Table of Contents

Other manuals for Kurzweil K2600

Related product manuals