7-28
Setup Mode and the Setup Editor
The SLIDER and SLID/2 Pages
The SLIDER and SLID/2 Pages
You can assign each of the K2600Õs eight programmable sliders to a destination on each of the
eight zones. Or, you can assign any combination of sliders to the same zone, allowing you
tremendous ßexibility. For example, you can assign Sliders A and B to modulate pitch and
volume on Zone 1, then assign Slider C to control panning on Zones 2, 3, and 4.
The SLIDER button gives you access to Sliders AÐD. Press the SLID/2 button to program
Sliders EÐH.
Take a look at the parameters. Since all the continuous controllers work in a similar manner,
youÕll Þnd these same parameters on the CPEDAL, RIBBON, WHEEL, and PRESS pages.
EditSetup:SLIDER||||||||||||||<>Zone1/1|
||||||||||||||||||||||||||||||||||||||||
|||||||Dest:|||Scale:Add:Curv:Ent:|Exit:
SlidA:|Data|||||100%|0|||Lin||None|None|
SlidB:|MIDI22|||100%|0|||Lin||None|None|
SlidC:|MIDI23|||100%|0|||Lin||None|None|
SlidD:|MIDI24|||100%|0|||Lin||None|None|
<more||SLIDER|SLID/2|FOOTSW|CPEDAL|more>
EditSetup:SLID/2||||||||||||||<>Zone1/1|
||||||||||||||||||||||||||||||||||||||||
|||||||Dest:|||Scale:Add:Curv:Ent:|Exit:
SlidE:|MIDI25|||100%|0|||Lin||None|None|
SlidF:|MIDI26|||100%|0|||Lin||None|None|
SlidG:|MIDI27|||100%|0|||Lin||None|None|
SlidH:|MIDI28|||100%|0|||Lin||None|None|
<more||SLIDER|SLID/2|FOOTSW|CPEDAL|more>
NOTE: The FOOTSW page, and all the switch-controller pages, are described following the section
called Switch Controller Parameters, which begins on page 7-32.
Parameter Range of Values Default
Destination (Slider A) MIDI Control Source list Data
Destination (Slider B) MIDI Control Source list MIDI 22
Destination (Slider C) MIDI Control Source list MIDI 23
Destination (Slider D) MIDI Control Source list MIDI 24
Destination (Slider E) MIDI Control Source list MIDI 25
Destination (Slider F) MIDI Control Source list MIDI 26
Destination (Slider G) MIDI Control Source list MIDI 27
Destination (Slider H) MIDI Control Source list MIDI 28
Scale ±300% 100%
Add -128 to +127 0
Curve Curve list (see text) Lin
Entry Value None, 0–127 None
Exit Value None, 0–127 None
To Next Page
Loading...
