15-22
Advanced KDFX
Real-time Control of KDFX
Notice that when FX Mode is set to Program or Setup, the studio is not shown, as it is when the
FX Mode is set to Master. So you canÕt go into a studio and edit it from this pageÑyou have to
go through the program or setup, from its KDFX page.
Note: When FX Mode is set to Auto, then FX Mode follows the K2600Õs operating modeÑitÕs
either Program or Setup. When you are on this page, however, FX Mode is actually Master. But
donÕt screw up your brain thinking about thisÑweÕll get back to it later in this chapter (KDFX in
Auto Mode on page 15-34).
For the sake of clarity, during most of this chapter we will talk about linking KDFX only with programs.
The procedures for linking KDFX to a setup are essentially identical, except for the setting of the
FX Mode.
The KDFX Pages
If you look inside any program, you will see several pages that handle the studio and KDFX
control assignments. Open up a program with the Edit button and press more> until you see
this at the bottom of the display:
<more||KDFX|||FXMOD2|FXMOD3|FXMOD4|more>
These are the FXMod setup pages, and in fact there are eight of themÑpress more> again to see
the others.
<more||FXLFO||FXASR||FXFUN||ImpFX||more>
Go back to the Þrst set (press <more), and press the KDFX soft button to look at the Þrst of the
FXMod setup pages:
EffectMode||||Xpose:0ST|||||<>Channel:1|
FX|Mode:Program
FX|Chan:1
Dither|:Medium||||||DigOut|:16 Bit
Octav-|Octav+|Panic||||||||Chan-||Chan+
EditProg:KDFX|||||||||||||||||All|Layers|
Studio:278|Hall+flange+rm||
Bus:|Param:|||||Adjust:||Source:||Depth:
FX1||Wet/Dry||||12%wet|||MWheel|||40%wet
FX2||Fdbk|Level|25%||||||MIDI23|||60%
InA||EQ1|Bass|G|0.0dB||||MIDI24|||21dB
<more||KDFX|||FXMOD2|FXMOD3|FXMOD4|more>
To Next Page
Loading...
