Multi Mode
Controllers
6-6
ARPEGGIATOR Section
ARP and LATCH Buttons
Press the ARP button to turn the Arpeggiator On or O. When the Arpeggiator is On, the
ARP button lights up.
e Arpeggiator allows you to easily play arpeggios or note sequences by holding down a
chord or a single note. Each Multi Zone can be saved with dierent arpeggiator settings. For
details on the Arpeggiator, see ARP Page on page 7-39.
With certain arpeggiator settings, pressing the LATCH button allows the arpeggiator to
continue playing after notes are released on the keyboard.
CC SEQ Button
Press the CC SEQ button to turn the CC Sequencer On or O. When the CC Sequencer is
On, the CC SEQ button lights up.
e CC Sequencer allows you to rhythmically modulate up to 4 Program parameters (such
as lter frequency) based on preset or user patterns. For details on the CC Sequencer, see CC
Sequencer (CC SEQ) Page on page 7-40.
TEMPO Section
Use the TEMPO section to set the tempo of the current Multi. e Multi tempo typically
sets the tempo of the Arpeggiator, ris, and the rate of tempo synced LFOs and FX (such
as Delay). To set the tempo press the TAP button a few times at the desired rate, or use the
TEMPO knob.
SW1 (SUSTAIN) and SW2 Pedals
e SW1 (SUSTAIN) pedal defaults to controlling sustain, which will sustain any note that
is played while the pedal is pressed, for as long as the pedal is held.
For KB3 Organ Programs, the SW1 (SUSTAIN) pedal controls the Rotary Speaker speed,
changing between fast and slow. e Display shows “KB3” when a Multi containing a KB3
Program is selected.
e SW2 pedal defaults to controlling Sostenuto, which will sustain notes from any keys that
are being held when the pedal is pressed, for as long as the pedal is held.
e SW1 (SUSTAIN) and SW2 pedals can be enabled, disabled, or reassigned for each Zone
in Multi Edit Mode. Because of this, the pedals may function dierently for each Zone in
each Multi.
Global Mode can be used to set pedal overrides, which can change the pedal assignments for
all Multis.
To Next Page
Loading...
