Kurzweil K2700 - Page 341

Global Mode
AUDIO I/O
9-30
Analog Input Mods in Program Mode
To control Analog Input Mods in Program Mode, rst make sure the Global “Analog In
FX Ctl” parameter is set to “Current Chan Ctl”. In Program Mode, the K2700’s physical
controllers send the MIDI CC numbers listed in the table below. If the selected Chain
contains Mods which use any of these MIDI CC numbers, eects parameters will be
controllable by using the physical controllers which have corresponding MIDI numbers.
Use the Chain editor if you wish to add Mods, remove Mods, or change their MIDI
assignments. Select the Chain eld and press the EDIT button to enter the Chain Editor. See
The MOD Pages on page 4-3 for details on editing Chain Mods.
K2700 Physical Controller MIDI CC Numbers
CC Controller CC Controller CC Controller CC Controller
0 22 Slider 3 73 Knob 2 90 Button 9
1 Mod Wheel 23 Slider 4 74 Pad 3 91
2 24 Slider 5 75 Pad 4 92 Pad 7
3
Knob 8
25
Slider 6
76
Pad 5
93
4
CC Pedal 2
26
Slider 7
77
Pad 6
94
Pad 8
5-8 27
Slider 8
78 95
Pad 9
9
Knob 9
28
Slider 9
79
Knob 4
96-101
10 29
Variation Button
80
Button 1
102
Pad 10
11
CC Pedal 1
30
Pad 2
81
Button 2
103
Pad 11
12
Slider 1
31-63 82
Button 3
104
Pad 12
13
Slider 2
64
Sw. Pedal 1a
83
Button 4
105
Pad 13
14
Knob 5
65 84 106
Pad 14
15 66
Sw. Pedal 1b / 2a
85
Button 5
107
Pad 15
16
Pad 1
67
Sw. Pedal 2b
86
Button 6
108
Pad 16
17
Knob 6
68-70 87
Button 7
109-127
18
Knob 7
71
Knob 1
88
19-21 72
Knob 3
89
Button 8
Audio Input Mods in Multi Mode
To control Global Mode Analog Input Mods in Multi Mode, the selected Multi must have
its Audio Input Mode set to “Use Global Mode Eects” on the Multi Edit Audio In FX
page. Next, make sure the Global “Analog In FX Ctl” parameter is set to “Current Channel
Control”. On the Multi Edit Controls page, use the Destination eld to assign a Multi
controller to send the desired FX Mod CC number (see CONTROLS Page on page 7-13
for details). e Zone used to send these CC numbers must have a MIDI Channel which
matches the current setting for the Multi’s “AuxFX Ch” parameter. See Channel on page 7-7
and Aux FX Channel on page 7-42 for details.