Chapter 4
Programming SP2
< Figure 4-22 Turning On and OFF switch pedal >
Assigning Knobs
You can program Knobs A‐D to send any MIDI control changenumber. Theprocedure is like
following:
Press[Setup]button and [Edit] button. While holding down [Knob Mode] button, turn one of
theknobsyouwanttoprogram.
< Figure 4-23 Selecting a Knob to be programmed >
The display will show which knob will be programmed for a short while and then the MIDI
controlnumbercurrently assignedtoit.See<Figure4‐24>.TheKnob tobeprogrammedisA
andtheassignedMIDIcontrolnumberis6.
４-12
To Next Page
Loading...
