Chapter 4
Programming SP2
1. Internal Setup
In fact, you can consider a program as a setup with only one zone. Thus, changing zone
parameters actually can affect how the program works. For example, in program mode,
pressing[Split]buttonactivatestheAutosplitfeaturebecausethevalueforAutosplitparameter
ofthecorrespondingzoneissettoONbydefault.Thus,youcanselectanyprogramorinternal
setupandmakeitastartingpointforyourownsetup.
2. Default Setup
Default Setup is a “blank” setup except for a handful of typical controller assignments with
AutosplitOff.Ifyouwanttocreateacompletelynewsetupfromscratch,werecommendyouto
useDefaultSetupasastartingpoint.
Nowyou’ reready tocreatenewsetups oreditexistingsetupsandstoretheminQuick Access
bank.
Tomake changes to setups, press [Setup] button and then,press[Edit]button. Pressing [Edit]
button will light the LED in it and the display will show the information about Main sound.
Users can edit parameters associated with those sounds with [Layer] or [Split] button. Select
soundsyouwanttoeditwith[Main],[Layer]or[Split]button.Use[KeyRangeButton] toedit
thekeyrangefortheselectedsound.
Key Range
Key Range determines where Main, or Split sound plays on the keyboard. For example, you
needtosetappropriaterangesforeachofyourbasses,padsandleadstoenjoytherealpowerof
the split feature. To set Key Range, press [Setup] button, [Edit] button, and then press [Key
Range]button inorder.TheLEDin[KeyRange]button willflash.Thedisplay willlooklike<
Figure4‐16>.
<Figure4‐16SettingtheLowestNotefortheZone>
Triggerthekeyyouwanttobethelowestnoteforthezone.Whenyoudo,thedisplaywilllook
like<Figure4‐17>.
<Figure4‐17SettingtheHighestNotefortheZone>
Trigger the key you want to be the highest note for the zone. When you do, the LED in [Key
Range]buttonwillbeturnedoff,andsettingthekeyrangeisdone.
４-9
To Next Page
Loading...
