Chapter 7
Effect
<Figure7‐2EffectWet/Dry>
MIDI Controller 93 and MIDI Controller 91 are assigned to control the wet/dry mix of Effect
andReverbblock.The valueof 0meanscompletelydry signalwithnoeffectprocessingatall.
Thevalueof127istheopposite‐processedsignalonly.
•MIDI91/REVERB•MIDI93/EFFECT
Routing Effect
Routing Effects is determining which block the audio signal will pass through. Literally, the
term“Routing”meansselectingpathsintheSP2’seffectenginealongwhichtosendtheaudio
signalgenerated by thesoundengine.Youcanalsomaketheaudiosignaltemporarilybypass
theeffectenginewithoutreprogrammingtheSP2.<Figure7‐3>
Whenyouselectaprogramorsetup,theLEDsintheEffectandGlobalbuttonswillindicatethe
currenteffectrouting.
<Figure7‐3RoutingEffect>
Selecting Effect
1. Press[Effect]button
2. Make sure the LED in the [Edit] button is blinking, which means that you are in the
EffectEditingmode.
3. Selectthedesiredeffecttypefromthecategory.Thecategoryincludeschorus,flanger,
delay,compressor,distortion,filter,laserverb,misc.(rotaryspeaker,enhancer,simple
motion, etc.) After you make selection, choose the desire preset with Sound Select
button.
4. Unless you store changes, the effect assignment reverts to its preset state as soon as
youyouselectanotherprogramorsetup.Ifyouchangetheeffectroutingforprogram
orsetupandpreservethechangedsetting,press[Store]button
5. Thedisplaywillaskyoutotobesure.Press[+/Yes]buttontoconfirm.
７-2
To Next Page
Loading...
