EasyManuals Logo

Kyocera ECOSYS M3540dn User Manual

Kyocera ECOSYS M3540dn
398 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
2-13
Installing and Setting up the Machine > Default Settings of the Machine
Network Setup (LAN Cable Connection)
The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP (IPv4),
TCP/IP (IPv6), NetBEUI, and IPSec. It enables network printing on the Windows, Macintosh, UNIX and other platforms.
This section explains the procedure of IPv4 settings for TCP/IP settings. The default settings are "TCP/IP Protocol: On,
DHCP: On, Auto-IP: On".
1
Display the screen.
1 Press the [System Menu/Counter] key.
2 Press the [ā–²] or [ā–¼] key to select [System/Network], and press the [OK] key.
3 Press the [ā–²] or [ā–¼] key to select [Network Setting], and press the [OK] key.
4 Press the [ā–²] or [ā–¼] key to select [TCP/IP Settings], and press the [OK] key.
NOTE
• If user login administration is enabled, you can only change the settings by logging in with administrator privileges.
If user login administration is disabled, the user authentication screen appears. Enter a login user name and
password, and press [Login].
The factory default login user name and login password are set as shown below.
• Ask your network administrator for the IP address in advance, and have it ready when you configure this setting.
In the following cases, set the IP address of DNS server on the Command Center RX.
- When using the host name with "DHCP" setting set to "Off"
- When using the DNS server with IP address that is not assigned by DHCP automatically.
Refer to the Command Center RX User Guide.
• For other network settings, refer to the Network Setting on page 8-8
.
Login User Name Login Password
4000 4000
21
Sys. Menu/Count.:
System/Network
Exit
03
Counter
02
01
Report
21
System/Network:
Network Setting
Exit
01
Optional Network
02
NW InterfaceSend
03
21
Network Setting:
TCP/IP Settings
Exit
01
WSD-SCAN
02
WSD-PRINT
03

Table of Contents

Other manuals for Kyocera ECOSYS M3540dn

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kyocera ECOSYS M3540dn and is the answer not in the manual?

Kyocera ECOSYS M3540dn Specifications

General IconGeneral
Print TechnologyLaser
Print Resolution1200 x 1200 dpi
Duplex PrintingYes
Scan TypeColor CIS
Scan Resolution600 x 600 dpi
Fax CapabilityYes
Fax Transmission Speed33.6 kbps
Paper Capacity500 sheets
ConnectivityUSB, Ethernet
CopyingYes
ScanningYes
Modem Speed33.6 kbps
Standard Input Capacity500 sheets
Standard Output Capacity250 sheets
Maximum Output Capacity250 sheets
Maximum Print SizeA4
Standard InterfacesUSB 2.0, Ethernet
Ethernet LANYes
Internal Memory512 MB
Power Consumption (typical)661 W
DisplayLCD
FunctionsPrint, Copy, Scan, Fax
Operating System CompatibilityWindows, Mac OS, Linux
Print Speed40 ppm (pages per minute)
Copy Speed40 cpm (copies per minute)
Standard Paper Tray Media TypesRecycled
Maximum Internal Memory1, 536 MB
Weight22 kg
Product ColourBlack

Related product manuals