5-4
Operation on the Machine > Loading Originals
Original Specifications available in the Document
Processor
The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals
are scanned.
Originals Supported by the Document Processor
The document processor supports the following types of originals.
Originals Not Supported by the Document Processor
Do not use the document processor for the following types of originals. Otherwise, the originals may be jammed
or the document processor may become dirty.
• Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases
before loading. Failure to do so may cause the originals to jam.)
• Originals with adhesive tape or glue
• Originals with cut-out sections
• Curled original
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam.)
• Carbon paper
• Crumpled paper
How to Load Originals
1
Adjust the original width guides.
Weight 50 to 120 g/m
2
(duplex: 50 to 120 g/m
2
)
Sizes Maximum 216 x 355.6 mm (Long-sized 216 x 915 mm) to Minimum 105 x 148 mm
No. of sheets ECOSYS MA4500ifx/ECOSYS MA4500ix: 75 sheets or less (50 to 80 g/m
2
)
ECOSYS MA6000ifx/ECOSYS MA5500ifx: 100 sheets or less (50 to 80 g/m
2
)
• Before loading originals, be sure that there are no originals left on the original eject table. Originals
left on the o
riginal eject table may cause the new originals to jam.
• Do not make an impact on the document processor top cover, such as aligning the originals on the
top
co
ver. It may cause an error in the document processor.
To Next Page
Loading...
Need help?
General