2-35
Installing and Setting up the Machine > Default Settings of the Machine
Default Settings of the Machine
The default settings of the machine can be changed in System Menu. Before using this machine, configure such
settings as date and time, network configuration, and energy saving functions as needed.
Setting Date and Time
Follow the steps below to set the local date and time at the place of installation.
When you send an E-mail using the transmission function, the date and time as set here will be printed in the
header of the E-mail message. Set the date, time and time difference from GMT of the region where the machine
is used.
1
Display the screen.
[Home] key > [...] > [System Menu] > [Device Settings] > [Date/Time]
2
Configure the settings.
[Time Zone] > [Date/Time] > [Date Format]
For settings that are configurable from System Menu, refer to the following:
Setup and Registration (System Menu) (page 8-1)
• To make changes after this initial configuration, refer to the following:
Date/Time (page 8-7)
• The correct time can be periodically set by obtaining the time from the network time server.
Command Center RX User Guide
Item Description
Time Zone Set the time difference from GMT. Choose the nearest listed location from the list. If
you select a region that utilizes summer time, configure settings for summer time.
Date/Time Set the date and time for the location where you use the machine. If you perform
Send as E-mail, the date and time set here will be displayed on the header.
Value: Year (2000 to 2035), Month (1 to 12), Day (1 to 31),
Hour (00 to 23), Minute (00 to 59), Second (00 to 59)
Date Format Select the display format of year, month, and date. The year is displayed in Western
notation.
Value: Month/Day/Year, Day/Month/Year, Year/Month/Day
To Next Page
Loading...
Need help?
General