10-20
Troubleshooting > Troubleshooting
Printed images are fuzzy.
Printed images are cut
off.
Is the device used in an
environment with high humidity or
where the temperature or humidity
changes suddenly?
Use in an environment that has
suitable humidity.
―
― Run [Drum Refresh]. page 10-40
Printed images are
skewed.
Are the originals placed correctly?
When placing originals on the platen,
align them with the original size
indicator plates.
page 5-2
When placing originals in the
document processor, align the
original width guides securely before
placing the originals.
page 5-4
Is the paper loaded correctly? Check the position of the paper
width guides.
page 3-3
Printed images have
vertical lines.
Is the slit glass dirty? Clean the slit glass. page 10-3
Dirt on the top edge or
back of the paper.
Is the interior of the machine dirty? Open the right cover. If the machine
interior is dirty with toner, clean it
using soft, dry, lint-free cloth.
page 10-2
Part of the image is
periodically faint or shows
white lines.
― Run [Drum Refresh]. page 10-40
Print on the back of the
sheet is visible on the
front.
― Set [Prevent Bleed-through] to
[On].
page 6-31
page 8-26
Symptom Checkpoints Corrective Actions
Reference
Page
To Next Page
Loading...
Need help?
General