Kyocera FS-6030MFP - Drive Section; Detaching and Refitting the Main Motor; Detaching and Refitting the Drive Unit

2K3/2L3
1-5-22
1-5-8 Drive section
(1) Detaching and refitting the main motor
Procedure
1. Remove the rear cover.
(See page 1-5-5)
2. Remove the connector from the engine
PWB.
3. Remove the wire from the hook.
4. Remove four screws and then remove
the main motor.
Figure 1-5-35
(2) Detaching and refitting the drive unit
Procedure
1. Remove the rear cover.
(See page 1-5-5)
2. Remove the connector from the engine
PWB.
3. Remove five screws and then remove
the drive unit.
4. Check or replace the drive unit and refit
all the removed parts.
Figure 1-5-36
Screws
Screws
Main motor
Engin PWB
Socket(YC16)
Connector
Connector
Hook
Wire
Screw
Screw
Screws
Screw
Drive unit
Connector
Engin PWB
Socket(YC1)
Connector