2K3/2L3
1-5-33
1-5-11 PWBs
(1) Detaching and refitting the main PWB
Procedure
1. Remove the rear cover.
(See page 1-5-5)
2. Remove the left lower cover.
(See page 1-5-6)
3. Remove the connector.
4. Remove the wire from the clamp.
5. Remove eleven screws and then
remove the controller box.
Figure 1-5-57
6. Remove all connectors for the main
PWB.
7. Remove seven screws and then
remove the main PWB.
8. Check or replace the main PWB and
refit all the removed parts.
Figure 1-5-58
Screws
Screws
Controller box
Connector
Clamp
Connector
Wire
Screws
Screws
Screw
Screw
Screw
Main PWB
To Next Page
Loading...
