Kyocera FS-6030MFP - Detaching and Refitting the Engine PWB; Detaching and Refitting the Power Source PWB

2K3/2L3
1-5-34
(2) Detaching and refitting the engine PWB
Procedure
1. Remove the rear cover.
(See page 1-5-5)
2. Remove all conectors from the engine
PWB.
3. Remove four screws and then remove
the engin PWB.
4. Check or replace the engine PWB and
refit all the removed parts.
CAUTION: When replacing the engine
PWB, remove the EEPROM (U12) from
the engine PWB that has been removed
and then reattach it to the new engine
PWB.
Figure 1-5-59
(3) Detaching and refitting the power source PWB
Procedure
1. Remove the rear cover and inner
tray.(See page 1-5-5,1-5-6)
2. Remove the power source fan
motor.(See page 1-5-23)
3. Remove all connecters from the power
source PWB.
4. Remove four screws and then remove
the power source PWB.
5. Check or replace the power source
PWB and refit all the removed parts.
Figure 1-5-60
Screw
Screw
Screw
Screw
Engine PWB
Screw
Screw
Screw
Screw
Power source PWB