Kyocera FS-9530DN - Page 140

2GZ/2G1
1-6-4
10. Confirm that the main switch is set to off.
11. Insert the memory card into the printer's
memory card slot.
Figure 1-6-7
12. Turn the main switch on.
13. When message display (1) is displayed to
detect firmware in the memory card.
14. Message display (2) is displayed during
downloading.
15. When message display (3) is displayed to
indicate downloading is finished.
16. Turn the main switch off.
17. Remove the memory card from memory
card slot.
18. Turn the main switch on.
19. Confirm that message display (4) is dis-
played after warm-up.
20. Print the status page. Print the status page
to check that the firmware version has been
updated.
Figure 1-6-8
Memory
card slot
Memory card
(2)
(1)
(4)
Ready
Supervisor mode
CF-card reading
Supervisor mode
(3)
2GZ_3000.001.021
05/10/27 [E1F9]
Supplement
(Normally: 00)
Classification
(Normally: 0)
Product code
2GZ: This machine
Release date:
Year/Month/Day
Checksum
Update history
Build number
Firmware category
10: Engine controlle
r
30: Main controller
Message display
Main switch: On
Main switch: On
Main switch: Off
Memory card
Memory
card slot