Kyocera KM-2530 - Job Separator; Key Counter; Printer Board; Printer;Scanner Kit

2DF
1-4-33
Maintenance
Description
item No.
U203 Operating DF separately
Description
Simulates the original conveying operation separately in the optional DF.
Purpose
To check the DF.
Method
1. Press the start key. The screen for selecting an item is displayed.
2. Place an original in the DF if running this simulation with paper.
3. Select the item to be operated. The selected item is displayed in reverse.
4. Select the magnification using the cursor up/down keys.
Display Operation Setting range Initial setting
ADF With paper, single-sided original 50 to 200 (%) 100
RADF With paper, double-sided original 50 to 200 (%) 100
ADF (NON-P) Without paper, single-sided original 50 to 200 (%) 100
(continuous operation)
RADF (NON-P) Without paper, double-sided original 50 to 200 (%) 100
(continuous operation)
5. Press the start key. The operation starts for the selected magnification.
6. To stop continuous operation, press the stop/clear key.
Completion
Press the stop/clear key when the operation stops. The screen for selecting a maintenance item No. is
displayed.
U204 Setting the presence or absence of a key card or key counter
Description
Sets the presence or absence of the optional key card or key counter.
Purpose
To run this maintenance item if a key card or key counter is installed.
Method
Press the start key. The screen for selecting an item is displayed
Setting
1. Select the optional counter to be installed using the cursor up/down keys. The selected counter is
displayed in reverse.
Display Description
KEY-CARD The key card is installed
KEY-COUNTER The key counter is installed
2. Press the start key. The setting is set and the screen for selecting a maintenance item No. is displayed.
Completion
To exit this maintenance item without changing the current setting, press the stop/clear key. The screen for
selecting a maintenance item No. is displayed.