1-3-4
2DF
1. Remove the tapes holding the front cover,
bypass tray, drawers and original detection
switch.
2. Remove the pad at the eject section.
3. Remove the three tapes holding the pins for light
source units 1 and 2.
4. Remove the tape holding the conveying cover.
5. Remove the two tapes holding the power cord.*
*120 V specifications only.
Remove the tapes and pad.
Figure 1-3-3
Figure 1-3-4
Pad
Tape
Tape
Tapes
Tape
Tapes
Tape
Tape
Tape
To Next Page
Loading...
