1-3-8
2DF
1. Place an original and make test copies.
1. Remove the PET film from the operation panel.
2. Fit the relevant function sheet.
If the DF has been installed, select a function
sheet among No. 1 to 4 based on installation of
the fax board and the printer board.
If the DF has not been installed, select a function
sheet among No. 5 to 8 based on installation of
the fax board and the printer board.
3. Refit the PET film to its original position.
Make test copies.
Attach the function seat.
Figure 1-3-11
PET film
PET film
Function seat
Completion of the machine installation.
To Next Page
Loading...
