Kyocera KM-2530 - Invert Copy Mode

2DF
1-3-40
Figure 1-3-73
Figure 1-3-74
17. Through the opening of controller-box above
the speaker, connect the FAX-PCB-Power
cable on the auxiliary power source PCB to
connector CN8 on the fax board.
18. Connect the 2-pin connector to the 2-pin
connector with green cable.
19. Unlock CN1 on the fax board by pulling its
connector housing.
20. Hold the fax cable with its conductive side
facing up, insert it into connector CN1, then
push the housing back in to lock the
connector.
21. Hold the other end of the fax cable with its
conductive side facing down, and connect it
to connector CN44 on the main PCB. (Pull
the CN44 housing out to release the
connector lock, then insert the cable, and
then push the housing back in.)
Important: Be sure to push the fax cable all
the way in, and be sure that the connection is
straight. A poor connection may result in a
variety of problems.
2-pin connector
with green cable
Connector CN8
2-pin connector
Fax board
FAX-PCB-Power cable
Auxiliary power source PCB
Connector CN44
Connector CN1
Fax board
Fax cable
CN1
CN44
Figure 1-3-75
Memory slot
Memory module
DIMM (8MB)
Important: The Memory module DIMM (8MB)
must be installed onto the fax board. Please be
sure that you do not install it onto the main PCB.
22. Insert the Memory module DIMM (8MB) at an
angle into the memory slot on the fax board.
23. Push the free end of the module down toward
the board.
1-3-38