CHAPTER 4 BASIC OPERATION
4-7
Touch the [+] key or [–] key to set the zoom ratio for the
vertical and/or horizontal direction.
The numeric keys can also be used by touching the
[# keys] key.
Check the direction of the original top side.
Copying will start when the [Start] key is pressed.
3. Interrupt copying
Interrupt copying is useful if, during one copy job, other originals
need to be copied at different settings. The interrupted copy job
can be resumed at the same settings as before after the rush job
is finished.
Press the [Interrupt] key to light the indicator. The “Inter-
rupt mode OK.” screen will appear.
Remove the present original(s) and put it (them) aside.
Set the new original(s) and execute copying.
When copying ends, press the [Interrupt] key again, and
replace the newly copied original(s) with the one(s) re-
moved before. Then, press the [Start] key.
The interrupted copy job will be resumed.
4
5
1
2
3
4
To Next Page
Loading...
