Kyocera KM-2530

CHAPTER 5 FUNCTIONS
5-3
Press the [Start] key.
Scanning will start.
When originals are set in the Document Processor, copy-
ing will start after scanning the set originals.
When an original is set on the platen, a message for
scanning the next original appears. Go to the next step.
Replace the original and then press the [Start] key.
Scanning will start.
When all originals are scanned, touch the [Scanning fin-
ished] key. Copying will start.
Specify the binding orientation of finished copies.
Check the orientation of originals according to the mes-
sage.
IMPORTANT
• If the orientation of the originals is incorrect, it may result in
wrong finished copies.
5
6
7
8
Start
Stop/
Clear
5 6
8 9
0
Inch specifications
Metric specifications
1-sided or 2-sided originals 2-page (open-face) originals
1-sided or 2-sided originals 2-page (open-face) originals
Inch specifications
Metric specifications
1-sided or 2-sided originals 2-page (open-face) originals
1-sided or 2-sided originals 2-page (open-face) originals
9
Metric specifications
Inch specifications
→→