Kyocera KM-3035

2FD/2FF/2FG
1-4-49
Maintenance
Description
item No.
U245 Checking messages
Description
Displays a list of messages on the touch panel of the operation panel.
Purpose
To check the messages to be displayed.
Method
1. Press the start key.
2. Select the item to be displayed.
3. Change the screen using the cursor up/down keys to display each message one at a time.
When a message number is entered with the numeric keys and then the start key is pressed, the message
corresponding the specified number is displayed.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
U246 Setting the finisher
Description
Adjusts various items if the machine is equipped with an optional finisher.
3000-sheet finisher: Adjusts the amount of slack in the paper in punch mode.
Booklet stitcher: Adjusts the booklet stapling position for each paper size.
Built-in finisher: Adjusts the side registration cursor stop position in the staple sort mode.
Purpose
Adjusts the amount of slack in the paper while in the punch section if, in punch mode, paper jams or is Z-folded
frequently due to too much slack in the paper, or, the position of punch holes varies due to too little slack in the
paper.
Adjusts the booklet stapling position in the stitching mode if the position is not proper.
To adjust when registration is not proper or staple position is shifted in the staple sort mode.
Start
1. Press the start key. The screen for selecting an item is displayed.
2. Select the item to be set and press the start key. The screen for executing each item is displayed.
Display Description
3000 FINISHER Adjustment of the amount of slack in the paper in punch mode
SADDLE FINISHER Adjustment of the booklet stapling position
INNER FINISHER Side registration cursor stop position
Setting the amount of slack in the paper
1. Change the setting using the cursor up/down keys.
Description Setting range Initial setting
Amount of slack in the paper -15 to +15 0
If the position of punch holes varies, increase the setting to make the amount of slack larger.
If paper jams or is Z-folded frequently, decrease the setting to make the amount of slack smaller.
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.
Setting the booklet stapling position
1. Select the size to be set. The selected item is displayed in reverse.
2. Change the setting using the cursor up/down keys.
Display Description Setting range Initial setting
Change in value
per step
A4R/LTR Adjustment of booklet stapling –125 to +125 0 0.25 mm
position for A4R/LTR size
B4R Adjustment of booklet stapling –125 to +125 0 0.25 mm
position for B4R size
A3R/LDR Adjustment of booklet stapling –125 to +125 0 0.25 mm
position for A3R/LDR size