1-3-8
2FD/2FF/2FG-3.0
1. Place an original and make test copies.
Make test copies.
Completion of the machine installation.
1. Install the toner disposal tank in the copier.
2. Close the front cover.
1. Connect the power cord to the connector on the
copier.
2. Insert the power plug into the wall outlet.
Figure 1-3-10
Connect the power cord.
Carry out initial developer setting (maintenance item U130).
Load paper.
Output an own-status report (maintenance item U000).
Exit maintenance mode.
1. Turn the main switch on and enter the maintenance mode by entering “10871087” using the numeric keys.
2. Enter “130” using the numeric keys and press the start key.
3. Press the start key to execute the maintenance item.
The drive stops within approximately 5 minutes.
4. Press the stop/clear key.
1. Load paper in the drawer.
1. Enter “000” using the numeric keys and press the start key.
2. Select “MAINTENANCE” and press the start key to output a list of the current settings of the maintenance items.
3. Press the stop/clear key.
1. Enter "001" using the numeric keys and press the start key.
The machine exits the maintenance mode.
1. Press the * key to enter default setting and press the [Print form] key. The counter report will be output.
Print out the user setting list.
Toner disposal tank
Install the toner disposal tank.
1-3-7-1
To Next Page
Loading...
