Kyocera KM-3035

2FD/2FF/2FG
1-5-43
(12)The leading edge of
the image is sporadi-
cally misaligned with
the original.
Causes
1. Feed clutch, paper feed clutch, bypass paper
feed clutch or registration clutch installed or
operating incorrectly.
Causes Check procedures/corrective measures
1. Feed clutch, paper feed clutch, bypass paper
feed clutch or registration clutch installed or
operating incorrectly.
Check the installation position and operation of the feed clutch,
paper feed clutch, bypass paper feed clutch and registration clutch. If
any of them operates incorrectly, replace it.
(14)Offset occurs.
(13)Paper creases. Causes
1. Paper curled.
2. Paper damp.
3. Defective pressure springs.
4. Defective separation.
5. Defective fans.
Causes Check procedures/corrective measures
1. Paper curled. Check the paper storage conditions.
2. Paper damp. Check the paper storage conditions.
3. Defective pressure springs. Replace the pressure springs.
4. Defective separation. Check the drum separation claws and heat roller separation claws.
5. Defective fans. Replace the fans.
Causes
1. Defective cleaning blade.
2. Defective fixing section.
Causes Check procedures/corrective measures
1. Defective cleaning blade. Replace the cleaning blade (see page 1-6-46).
2. Defective fixing section. Replace the heat roller and press roller.