3-1-28
2A3/4
3. Slide the paper size label sheet into the front of drawer.
Paper size label sheet
Figure 3-1-35
4. If the user requests the side guides to be fixed, fix according to the paper size
using four M3 × 8 flat-head screws.
Side guides
Screws
Screws
Figure 3-1-36
5. Set the paper size on the operation panel. (For 220 - 240 V specifications only)
1. Place an original and make test copies.
Check if the center lines of the large paper deck, the bypass table and each
drawer are correct. If not, adjust the center lines.
Completion of the machine installation.
Make test copies.
To Next Page
Loading...
