3-1-48
2A3/4
3. Fit the MMD host monitoring system device to the rear cover using the two bronze
binding tap-tight screws M3 × 16.
4. Insert the connector of the signal cable into the connector of the MMD host
monitoring system device, and tighten the two screws on the signal cable.
Screws
(bronze binding
tap-tight M3 × 16)
Screw
Screw
Rear cover
MMD host monitoring
system device
Figure 3-1-61
5. Insert one connector of the modular connector cable into the "LINE" jack on the
MMD host monitoring system device and the other into a telephone jack.
LINE
TEL
Modular connector cable
Figure 3-1-62
To Next Page
Loading...
